如何測試下面的指南針電路? |
答題得分者是:ScottWang
|
正能量使者
一般會員 發表:4 回覆:1 積分:1 註冊:2010-01-04 發送簡訊給我 |
|
阿信
版主 發表:111 回覆:983 積分:813 註冊:2005-03-10 發送簡訊給我 |
|
阿信
版主 發表:111 回覆:983 積分:813 註冊:2005-03-10 發送簡訊給我 |
This is our first proto-type.
The KM Z51 is powered with 5.1V through the 420 Ohm-resistor and stabilized by the means of the Z-diode. The 1 microFarad Capacitor is discharged through R1 and the KM Z51 internal flip coil whenever the switch is operated. This produces a high and short current pulse. R1=(5 - flip coil resistance). The 100k potentiometer is used for offset-regulation. Use a screw-potentiometer and be patient ! The LM 324 is used in a first stage as differential-amplifier and comparator. The last stage is an inverting amplifier. The signal is sent to the RCX through the 1 kOhm resistor. Remember to set the sensortype to light-type. This will cause the RCX to send alternatively a 3 ms power-supply followed by a 0.1 ms-sensor-reading. The 22 microFarad capacitor acts as the power-supply during the reading-phase. The extreme sensitivity of the sensor causes a remarkable drift of the returned values. If the sensor-mode is set to percent-mode, the values will variate from 0 to 95. 這是我們初次的原型。 5.1V的稽納二極體經過420Ω電阻是用來穩壓給KM Z51。 1uF電容用來放電,經R1與KM Z51內部線圈電阻在開關動作時。 產生高而短的電流脈波,R1=5-內部線圈電阻。 100K半可變電阻用來做偏移調整。使用鏍絲起子,保持耐心。 LM324用在一級差動放大器及比較器。 最後一級是一個反向放大器。 信號經由1KΩ電阻傳送到RCX端。 記得設定偵測器型式為「亮型式」。 這會導致RCX發送或者3mS電源供應接著是0.1mS感測器讀取。 22uF電容工作在電源供應的讀取期間。 感測器極為敏感使傳回值有明顯變化。 若偵測器型式設定為「百分比模式」,它的值會在0~95變動。 |
ScottWang
版主 發表:32 回覆:486 積分:688 註冊:2009-04-27 發送簡訊給我 |
阿信版主很辛苦的翻譯,不過在看的時候,總覺得有一些地方怪怪的,所以就嘗試以不同的方式呈現,若您有更好的解釋,或者能把它修得更順暢,也歡迎提出來,謝謝.
>The 1 microFarad Capacitor is discharged through R1 and the KM Z51 internal flip coil whenever the switch is operated. >1uF電容用來放電,經R1與KM Z51內部線圈電阻在開關動作時。 這將會使得RCX去輪流發送,一個3mS電源供給,緊接著是0.1mS感測器讀取。 >The 22 microFarad capacitor acts as the power-supply during the reading-phase. >22uF電容工作在電源供應的讀取期間。 若偵測器 模式 設定為「百分比模式」,它的值會在0~95之間變動。 (雖然Mode以型式做解釋,字面意思不能算錯,但在電腦或電子方面可能會產生誤解,一般來說型式是用Type or Model,大都用於區別不同的產品,Mode則是電腦或單晶片設定用的一種模式,或者一般開關選擇的一種模式)
------
高壓直流電源供應器,高壓模組,測試LED專用AC LED定電流源,全範圍可調電壓電流, 中低壓直流電源供應器,電壓放大器,電流放大器,帶通濾波器,高精度參考電壓, 標準電壓,恆流源(定電流源),恆壓源(定電壓源),大電流電源供應器. 接受訂製,設計生產各種特殊規格,高精度產品,學校實驗室,研究單位實驗設備, 另可接受其它電子專案設計,HV Power,Vmax=20KV,Imax=2000A. http://hvpower.myweb.hinet.net/ |
阿信
版主 發表:111 回覆:983 積分:813 註冊:2005-03-10 發送簡訊給我 |
本站聲明 |
1. 本論壇為無營利行為之開放平台,所有文章都是由網友自行張貼,如牽涉到法律糾紛一切與本站無關。 2. 假如網友發表之內容涉及侵權,而損及您的利益,請立即通知版主刪除。 3. 請勿批評中華民國元首及政府或批評各政黨,是藍是綠本站無權干涉,但這裡不是政治性論壇! |