關於Thread與COM的使用疑問?! |
尚未結案
|
amide
一般會員 發表:4 回覆:13 積分:13 註冊:2002-07-11 發送簡訊給我 |
|
william
版主 發表:66 回覆:2535 積分:3048 註冊:2002-07-11 發送簡訊給我 |
|
amide
一般會員 發表:4 回覆:13 積分:13 註冊:2002-07-11 發送簡訊給我 |
|
william
版主 發表:66 回覆:2535 積分:3048 註冊:2002-07-11 發送簡訊給我 |
引言:william兄: 不是很了解你的意思,我應該怎麼設定Pool呢?! 可否請你敘述清楚一點呢?! 感謝~~I think one of the COM (COM plus, I cannot see the plus sign in previewing this message) enhancement over COM/DCOM is the support of object pooling (i.e. object reuse)... Open Component Services under Administrative Tools, select Component Services and then your computer. Find the COM application and its Components, in the Activation tab page of its properties you should find the support of object pooling (ungrayed only when you object supports object pooling). Refer to your original question, COM supports queuing (I have little experience on it) which requires installation of MSMQ serivces. |
Ktop_Robot
站務副站長 發表:0 回覆:3511 積分:0 註冊:2007-04-17 發送簡訊給我 |
本站聲明 |
1. 本論壇為無營利行為之開放平台,所有文章都是由網友自行張貼,如牽涉到法律糾紛一切與本站無關。 2. 假如網友發表之內容涉及侵權,而損及您的利益,請立即通知版主刪除。 3. 請勿批評中華民國元首及政府或批評各政黨,是藍是綠本站無權干涉,但這裡不是政治性論壇! |